Hog Roast DIY Installation Brackets - Large
is backordered and will ship as soon as it is back in stock.
This kit is designed to affix to either an existing BBQ or half barrel so that it can be used as a hog roast spit.
All components are made from stainless steel.
The uprights measure approximately 25mm x 50mm x 690mm. The skewer support can slide up and down the upright and lock on at any position using the locking pin. The upright without this sliding bracket will have the motor affixed to it.
Each upright has 2 drilled holes with nut and bolt supplied. These can then be bolted to your existing setup.